search

VALVE GUIDE PULLER TOOL

€64.50
Tax included

Valve guide extractor tool.

Compatibilité :

MB/GPW/M201   CJ-2A   CJ-3A   CJ-3B  

Quantity
Out-of-Stock

Recommendations:

- Fragilize the guide by piercing it before using the extractor.( drill at 12 mm).

- Make a cardboard stencil with a hole for the guide.

- Heat the area around the guide using a heat sink.(dilatation)

- Put the stencil on the guide, then retract the guide by cooling it with the Cryoredox (retractation)

- Finally use the extractor.

Warning: If the guides are too strong to go out, you first need a red heater from the guides to burst the rust.The supplied stem is 8 mm, it does not have the strength of a hydraulic jack.If the guide is too welded to the block, the stem breaks because it is used with too much force and it cannot support it.No warranty will therefore be possible regarding the break of this stem.

WO-T0003

You might also like