

Finger clutch mechanism with 8.5" (215mm) disc and ball stop
MB/GPW/M201 CJ-2A M38 M38A1 CJ-3A CJ-3B
WARNING!It is imperative to achieve the tilted finger setting before the engine is started
The setting is done by loosening the nut on the adjustment screws.
Turn around vis, until the distance between finger support surface and face of clutch support or settled 27/32" = 21.43 mm
The fingers must be adjusted in such a way that the ball stop hits simultaneously the three fingers support surfaces.
Then go up the steering wheel on the engine.
You might also like